How to Fix Netgear Orbi Not Showing Attached Devices Issue?

Netgear Orbi is actually a preferred choice when it comes to enjoying seamless internet connectivity across the length and breadth of your home or office. But there may be times when you may witness the Netgear Orbi not showing attached devices issue arising due to a variety of reasons ranging from your Netgear Orbi remaining out of sync with the Satellite to the presence of outdated Orbi firmware.

This guide comes with a whole host of solutions that can help you fix the Netgear Orbi not showing attached devices quickly so that you can say goodbye to the possibility of the Netgear Orbi not showing attached devices issue potentially emanating in the near future.

Attempting to reboot your Netgear Orbi

The primary solution to fix the Netgear Orbi not showing attached devices issue is to perform a reboot of your Orbi device which can be given effect by simply unplugging your Orbi device from the Power socket followed by plugging it back in after waiting for a couple of minutes.

Performing an Orbi Firmware Update is also a Feasible Solution

Whenever your Orbi Wi-Fi system starts performing unusually it becomes quite obvious to say that trying to execute an Orbi firmware update may help you fix the Netgear Orbi not showing the attached devices issue.

In a normal scenario, the Orbi firmware update can be performed in two different ways with one being the regular Orbi firmware update using the Graphical User Interface approach of effectuating the firmware update and the other involving the application of the Orbi App.

Establishing the Sync Between Orbi and the Satellite

A well-established criterion to fix the Netgear Orbi not showing attached devices issue is to bring your Orbi Wi-Fi system in sync with the Satellite in the way discussed underneath.

Step 1 - Place Orbi and the Satellite within each other’s range.

Step 2 - Now plug these into the power sockets and turn them on.

Step 3 - At this point in time you have to look around both these devices for the “Sync” buttons followed by pressing the same back to back which eventually will help you fix the Netgear Orbi not showing attached devices issue.   

Resetting your Orbi Wi-Fi is also a Possible Option

If the above three troubleshooting tips have not been able to allow you to fix the Netgear Orbi not showing attached devices then you must proceed with resetting your Orbi Wi-Fi device.

While getting this done you must remember that if you reset your Orbi then the customized settings will wither away which makes a strong case that you make a backup of the existing Orbi settings to avoid any inconveniences going forward.

Try setting up your Orbi Once again

In a bid to fix the Netgear Orbi not showing attached devices, you are advised to reconfigure your Orbi Wi-Fi by following the instructions mentioned in the step-by-step procedure below.

Step 1 - Just initiate by connecting your Orbi and modem by following the syncing strategy discussed in the middle of this guide.

Step 2 - Now attempt to visit the orbilogin.net or the orbilogin.com followed by logging in with the basic credentials.

Step 3 - Now adhere to the on-screen prompts and cause to restore the required settings eventually.