Why is Netgear WiFi Extender Not Showing Up?

Netgear WiFi Extender not showing up may have intermittently led to several inconveniences but the same can be fixed quite easily by executing a number of appropriate troubleshooting steps mentioned in this quick handy guide suitably drafted to be at your disposal always.

Trying to Update your Netgear Firmware

The issue of the Netgear WiFi  Extender not showing up may be related to the outdated Netgear firmware which can be fixed by updating the same regularly in a manner as enshrined below.

Step 1 - When you are on your Smart Device, just go to mywifiext.net followed by logging on to the Control Panel using the default login credentials.

Step 2 - Now to finalize the update just go selecting the “Firmware” option followed by adhering to the on-screen instructions.

You can also look forward to troubleshooting the Extender Installation    

1 - Ensuring that Power Source is not Faulty

Kindly check and ensure that your Netgear Extender is well connected to a reliable and consistent Power Source and that your Netgear Extender is beyond the clutches of strips and dividers.

2 - Make sure that Router and Extender are in a Suitable Range 

You may witness a degree of wireless inefficiency if your Router and Extender do not come in an appropriate field. This may cause the issue of the Netgear WiFi  Extender not showing up which can be quickly addressed by bringing your Router and Extender closer.

3 - Checking interference Might Also Help

If any cordless phone, television, or other transmitters pose hindrance in the form of interference to your Router and Extender you must remove such clutter to enforce better internet connectivity by virtue of your Netgear Extender.   

Executing the Factory Reset for your Netgear Extender

Another effective means of addressing the issue of the Netgear WiFi  Extender not showing up is perhaps executing a comprehensive Factory Reset on your Netgear Extender in the following way.

Step 1 - Take a pen or a fine paperclip and continue by inserting it into the small hole appearing on the device’s surface.

Step 2 - Hold that button for a time span of fifteen seconds and wait for your Extender to blink twice.

Step 3 - Now release the button and wait so that the Factory Reset can take effect.

Enabling SSID and Changing the Wi-Fi Channel

You may be witnessing the issue of Netgear Extender not showing up as your network may be transmitting frequencies on the 5GHz channel thereby making your receiver disappear from the network list. To check this up you must make sure that your network is enabled and you have configured appropriate Wi-Fi settings.

Step 1 - Initially, you must access the Wi-Fi settings followed by setting up the 2.4 GHz network simply by going to the “Wireless Setup” under the “Wireless” segment.

Step 2 - Now you have to place a tick on the “Enable SSID Broadcast” check box followed by choosing the WPA2 PSK [AES] under the Security Options.  

Step 3 - Finally cause the Settings to get saved followed by exiting the Control Panel.